Epson Photo750 manual Errors, Printer Status displayed on the control panel, Indicators

EPSON Stylus Photo 750 Revision A

Table 1-19. Printer Status displayed on the control panel

		Indicators
Printer Status
	Power	Ink Out	Ink Out	Paper Out	Priority
		(Black)	(Color)
Power on condition	On	--	--	--	9
Ink sequence	Blink	--	--	--	6
Ink cartridge	Blink	--	--	--	5
exchange mode
Data processing	Blink	--	--	--	8
Paper out*1	--	--	--	On	4
Paper jam*1	--	Off	Off	Blink	3
No ink cartridge or	--	On	--	--	7
Ink out (black)
Ink level low (black)	--	Blink	--	--	7
No ink cartridge or	--	--	On	--	7
Ink out (color)
Ink level low (color)	--	--	Blink	--	7
EEPROM and		On	On	On
	--	(for 1	(for 1	(for 1	--
Timer IC reset*2
		second)	second)	second)
Maintenance	Blink	Blink	Blink	Blink	2
Request
Fatal Error*1	Blink	On	On	Blink	1

NOTE: *1	Refer to “Fatal Error” under the “Errors” on page -23.
*2	EEPROM reset does not mean to erase all address in
	EEPROM. (See “Special Setting Mode” on page -22)
*3	-- in the table above means no change.

1.4.6 Errors

In this printer, when the following conditions are detected. the printer goes to the error condition, sets ERROR signal Low and BUSY signal High and stops receiving the data. The printer becomes unable to print at this time. However, if the printer communicated by IEEE1284.4 protocol, the printer does not become unprintable state.

†Ink Out

When the printer runs out most of the ink of any one color, it indicates ink-low warning and keeps printing. When the print runs out the whole ink of any one color, it indicates ink-error and stops printing. Exchanging ink cartridges is required on this state. An ink cartridge taken out once should not be used again. Re-installation of the cartridge upsets the ink level detection and may cause a serious problem to the print head as a result.

C A U Never use or re-install the cartridge, which is taken out once. Re-installation of the used cartridge disturbs the normal ink out detection.

†Paper out

When the printer fails to load a sheet, it becomes “paper out error” condition.

†Paper Jam

When the printer fails to eject a sheet, it becomes “paper jam error” condition.

Product Description Function 23