EPSON Stylus Photo 750 | Revision A |
4.2.5.6 Paper Feed Roller Assembly Removal
1.Remove “ASF, Assembly”. (See “ASF, Assembly Removal” on page
2.Remove “Torsion Spring,41.2” by unhooking one end from the ASF frame and remove “Lever, Brake”.
3.Remove “Bush, Fixing, Shaft” from the right end of “Shaft, Roller, LD” and remove “Lever, Hopper, Release”.
4.Move the left paper feed to the center and remove the cam fixing bush (white plastic) attached to the left side of “Shaft, Roller LD”.
5.Push the “Shaft, Roller, LD” to the left and remove the “Bush, Fixing, Shaft, Left” after releasing its hook.
6.Unlock the right and left bottom edges of “Hopper Assembly” from the “Frame, ASF”.
7.Push out “Shaft, Roller, LD” to the right while lifting up the right side of “Paper Feed, Roller Assembly, Right”, and remove “Shaft, Roller, LD” from the left side of “Frame, ASF”.
8.Pull out cam part of “Hopper, Assembly” from the right hole of “ASF, Frame”, holding down the “Upper, Assembly” by hand. From “ASF, Assembly”, left and right “Paper Feed Roller Assembly” and “Hopper, Assembly” will be separated.
CH E „ When removing or installing the “Hopper,
P O I | Assembly”, be careful not to let the grease attach to |
| the other parts. If it is attached, wipe off completely. |
„Be careful of the direction when installing “Lever, Hopper, Release”.
„Make sure that bushes at the both ends of the shaft are firmly attached.
H O P P E R , A S S E
L E V E R , B R A K E
T o r s io n S P R I N G , 4 1 . 2
C A M p a r t
F R A M E , A
B U S H , F I X I N G ,
S H A F T , L E F T
L E V E R , H O P P E
P a p e r F e e d R o ll
e
r A s s e m b ly
B U S H , F I X I N G
S H A F T , R O L L E R , L D
Figure 4-17. ASF Disassembly
Disassembly and Assembly | Disassembly | 66 |
