Epson Photo750 manual 5.5 ASF, Assembly Removal

EPSON Stylus Photo 750 Revision A

4.2.5.5 ASF, Assembly Removal

1.Remove the upper housing.(See “Housing Removal” on page -54)

2.Release the hook and remove “Gear,34” from the roller shaft of “ASF, Assembly”.

S h a f t , F ix in g , C R

[ C B S w it h w a s h e r ]

G e a r , 3 4

3.Remove the cable from a hook of “ASF Assembly” and cable hook of the “Printer Mechanism”.

4.Remove a “Shaft, Fixing, CR” and one screw securing “ASF, Assembly” to the printer mechanism frame.

5.Remove the “ASF Assembly” from the mechanism by detaching the projection at the left of “ASF Assembly” from the hole of the mechanism.

CH E „ When assembling “ASF, Assembly”, make sure that

P O I “ASF, Assembly” is firmly attached to the mechanism.

„Use the fixing screws at the specified positions below.

*Printer Left side: “Shaft, Fixing, CR”

*CR motor side: CBS Screw with washer

T h e p r o je c t io n s o f A S F m u s t b e in t h e s e h o le s

Figure 4-16. ASF, Assembly Removal

C A U TWhenI O installingN the “ASF, Assembly”, be sure that no cables are pinched between “ASF Assembly” and frame. Especially, if the cables from the motor is pinched, there is a danger of short-circuit and possibly causes hazardous problem such as over- heating or burning of components.

Disassembly and Assembly Disassembly 65