Video input connections | Extron electronic DDS 402 guide

7 1

100-240V 50-60Hz

1

I

N

P

U

T

S

	3			4		5	6
	2
			O
R	G	B	U		R	G	B
/R-Y	/Y	/B-Y	T		/R-Y	/Y	/B-Y
			P	RGB/R-Y, B-Y, Y			REMOTE
			U
H	V		T		H	V	S
/HV			S

2A MAX

RGB

RGB/R-Y, B-Y, Y

RGB/HD R-Y, B-Y, Y

2

Figure 2-2 — DDS 402 rear panel connectors

Video input connections

1Input 1 (computer video) input (top) connector — Connect computer or RGB

video to this female 15HD connector.

1

RGB

2Input 1 (computer video) loop-through (bottom) connector — Connect a local monitor to this female 15HD connector. The scaler buffers the computer video input and loops it on this connector.

The Digital Display Scaler buffers the computer video input signal before passing it to the loop-through connector. Beyond that, it does not alter the loop-through video in any way. The loop through output is the same resolution and frequency as the computer video input.

3Input 2 (RGB or component video) connectors — Connect RGBHV, RGBS, RGsB, or component video (R-Y, Y, B-Y for YUVi or YUVp, or Betacam) to these female BNC connectors (figure 2-3).

Ensure that the correct Input 2 video format is selected from the front panel menu, see Input #2 submenu, in chapter 3, Operation, or via the RS-232 port, see chapter 4, Programmer’s Guide, and chapter 5, Scaler Software.

R	G	B	R	G	B
/R-Y	/Y	/B-Y	/R-Y	/Y	/B-Y
H	V		H	V
/HV			/HV
RGBHV video			RGBS video
R	G	B	R	G	B
/R-Y	/Y	/B-Y	/R-Y	/Y	/B-Y
H	V		H	V
/HV			/HV
RGsB video			Component video (R-Y, B-Y, Y)

Figure 2-3 — Input 2 connections for RGBHV, RGBS, RGsB and component video

For RGBHV video — Connect to five BNC connectors.

For RGBS video — Connect to four BNC connectors.

For RGsB and component video — Connect to three BNC connectors.

Video output connections

The two video output connectors, the 15HD connector and the five BNC connectors, both output the same video signal. The 15HD connector outputs RGBHV only, not RGBS.

4RGB/HD R-Y, B-Y, Y Output 15HD connector — Connect an RGB video or HD component video display to this female 15HD connector.

Digital Display Scaler • Installation

2-3

Image 19

Extron electronic DDS 402 manual Video input connections, Video output connections

Contents

Digital Display Scaler DDS Instrucciones de seguridad Español Safety Instructions EnglishConsignes de Sécurité Français Sicherheitsanleitungen Deutsch QS-1 Rear panel video outputs QS-2 Default display cycleQuick Start DDS 402, cont’d Main menu Input menu Output menu Memory Presets menuQS-3 Exit menu Advanced Configuration menuPicture Adjustments menu Executive Mode menu Table of Contents Table of Contents, cont’d Digital Display Scaler Table of Contents Iii Iv Digital Display Scaler Table of Contents One Digital Display Scaler Introduction Introductiontroduction, cont’dAbout this Manual About the Scaler Features Introduction, cont’d Digital Display Scaler Introduction Introduction, cont’d Two Cabling and Rear Panel Views Installationstallation, cont’dInstallation Overview Mounting the Scaler Video output connections Video input connections RS-232 connection Installation, cont’dConfiguration Power connection Three Input buttons Front Panel Controls and IndicatorsOperationeration, cont’d Freeze button Menu control buttons Picture adjustment buttonsAdjustment knobs LCD display Button icons PowerOperation, cont’d Front Panel Operations Input Configuration menu Configuration Output Configuration menu Pixel Phase submenuInput #2 submenu Sync Polarity submenu Resolution and refresh rates submenuResolution 50 Hz 56 Hz 60 Hz 75 Hz 85 Hz Lock at 50/60 Hz Output Signal submenu Erase Presets submenu Save Presets submenu Test Pattern submenu Blue Mode submenuRGB Delay submenu Edge Smoothing submenu Reset submenu Picture adjustments Adjust knobs have no mechanical limits to their rotation Front panel security lockout executive mode Optimizing the Video Setting up a DVD source Four Digital Display Scaler Programmer’s Guide Symbols Scaler-Initiated Messages Test pattern RGB delayPresets Programmer’s Guide, cont’d Using the Command/Response Table Scaler Error ResponsesHost-to-Scaler Instructions Command Ascii Command Response Additional description Command/response table for SIS commands Command/response table for SIS commands cont’d Test pattern Command Ascii Command Response Command/response table for special function SIS commands Programmer’s Guide, cont’d Five Digital Display Scaler Scaler Software Installing the softwareUsing the control program Control Software for Windows Control program I/O configuration window Using the help program Scaler Software, cont’d Using the softwareButton Label Generator AAppendix a Digital Display Scaler Reference Information Specifications Included parts Part number Part NumbersIncluded parts Suggested part Reference Information, cont’d Firmware Upgrade Installation U24 U60 U68U67 Button Labels Installing labels in the scaler’s buttons FCC Class a Notice Extron’s Warranty Extron Electronics, USA