Extron electronic MLC 52 manual Wiring for IR control, Wiring the control connector for IR

Wiring for IR control

If you intend to control display and/or input devices via infrared (IR) commands from the MLC, you can connect Extron IR emitters or an IR Broadcaster to the

IR Out pin of the control connector. Up to two IR emitters can be connected via this connector at one time. Wire the connector as shown in the following illustrations.

			White striped wire only		IR
				Emitter
E	Modulated IR				Connect up
					to 2 IR
D	Ground				Emitters
					(max.)
		100 feet (30.5 m) maximum		(#70-283-01).

MLC 52 control connector

F E D C B A

IR

For the IR Emitter only

Place the head of each IR Emitter over or directly adjacent to the controlled device’s IR receiver.

E Demodulated IR

D Ground

A +12VDC output

MLC 52 control connector

F E D C B A

To IR Broadcaster with Emitter port (#60-272-02)

IR

For the IR Broadcaster with emitter port

EDemodulated IR

D Ground

MLC 52 control connector

F E D C B A

To the projector's wired remote port

(Connector type and pin configurations may vary depending on the projector model.)

IR

For a wired projector remote port

Wiring the control connector for IR

MLC 52 Series MediaLink Controllers • Installation 2-11