Extron electronic MLC 52 manual Programming video inputs projector remote control type B

Special Applications, cont’d

Programming video inputs — projector remote control type B

1. Place the rear panel configuration DIP switch #1 in the On (up) position to enable learning mode. (If the MLC is already in learning mode, proceed to step 2.)

ON
1	2	3	4

2. Using IR learning, program command “A” from the Video input selection button on the projector’s remote control into memory block #1 of the MLC 52’s Video or blank (for VC models) button as follows:

a. Press the Video button on the MLC front panel. The button blinks, indicating that the MLC is ready to learn the command. On the rear panel, the bottom IR learning LED flashes.

b. Within 5 seconds (while the Video button on the MLC 52 is blinking), press the Video button on the projector’s remote control. The MLC has learned command “A” for Video.

When a command has been successfully learned, the IR learning LEDs on the MLC rear panel flash in rapid progression from the top to the bottom, then back to the top.

3. Program the input selection command “B” from the Video input selection button on the projector’s remote control into memory block #2 of the MLC 52’s Video button as follows:

a. Press the Video button on the MLC front panel. The button blinks, indicating that the MLC is ready to learn the command. On the rear panel, the second LED from the bottom flashes.

b. Within 5 seconds (while the Video or blank button on the MLC 52 is blinking), press the Video button on the projector’s remote control. The MLC has learned command “B” for Video.

4. When finished programming the MLC 52 buttons, return configuration DIP switch #1 to its Off (down) position.

5. Test the system.

	DISPLAY
ON	OFF
VOL	PC
VOL	VIDEO

Command #1: RGB / IR Command “A”

Command #2: RGB / IR Command “B”

Command #1: Video / IR Command “A”

Command #2: Video / IR Command “B”

COMPUTER		VIDEO
VIDEO	AUDIO	A/V
MUTE	MUTE	MUTE
MENU		ENTER

CONT/ COL/

SIZE CENTER BRT TINT

SHARP	PHASE	ASPECT
		RATIO

MLC 52

Projector Remote Type B

Programming MLC 52 input selection buttons from a projector remote control type B

4-14 MLC 52 Series MediaLink Controllers • Special Applications