Extron electronic MLC 52 manual Replacing button labels, Replacing a button label

MLC 52

Standoff

Faceplate

Installing the MLC onto a new faceplate (bottom view)

Replacing button labels

The button caps are prelabeled for your convenience by default. However, you can change them with the included button labels.

The button assembly consists of a clear lens cap, the button label, and a white diffuser. (See the diagram below.) Remove the button assembly from the MLC 52 as follows:

1.Remove the button assembly by inserting a small, flat-bladed screwdriver, such as an Extron Tweeker, between the button’s base and the diffuser to gently pry the button assembly off the button plunger, as shown in the drawing at right.

2.Locate the small corner notch on the lens cap, and

slide the screwdriver between the lens cap and the diffuser. (See b in the illustration below.)

3.	Using a rotating motion of the screwdriver,
	carefully pry the two pieces apart. (See c in the

illustration below.)

Pry the button from the base.

Plunger

Base

Clear Lens	3	Diffuser
		Button Label
2	Pry the two
	pieces apart.
	Notch

Separate the two- piece button here at the corner.

Replacing a button label

MLC 52 Series MediaLink Controllers • Installation 2-5