Extron electronic MLC 52 manual Programming video inputs projector remote control type a

Special Applications, cont’d

b. Within 5 seconds (while the PC button on the MLC 52 is blinking), press the RGB 2 button on the projector’s remote control. The MLC has learned command “A” for RGB 2.

4. Program the input selection command “B” from the RGB 1 input selection

button on the projector’s remote control into memory block #3 of the MLC 52’s PC button as follows:

a. Press the PC button on the MLC front panel. The button blinks, indicating that the MLC is ready to learn the command. On the rear panel, the third LED from the bottom flashes.

b. Within 5 seconds (while the PC button on the MLC 52 is blinking), press the RGB 1 button on the projector’s remote control. The MLC has learned command “B” for RGB 1.

5. Program the input selection command “B” from the RGB 2 input selection button on the projector’s hand-held remote control into memory block #4 of the MLC 52’s PC button as follows:

a. Press the PC button on the MLC front panel. The button blinks, indicating that the MLC is ready to learn the command. On the rear panel, the fourth LED from the bottom flashes.

b. Within 5 seconds (while the PC button on the MLC 52 is blinking), press the RGB 2 button on the projector’s remote control. The MLC has learned command “B” for RGB 2.

6. If finished programming the MLC 52 buttons, return configuration DIP switch #1 to its Off (down) position, and test the system.

If you want to program video input selection at this time, proceed to “Programming video inputs — projector remote control type A,” below.

Programming video inputs — projector remote control type A

1.Place the rear panel configuration DIP switch #1 in the On (up) position to enter learning mode. (If the MLC is already in learning mode, proceed to step 2.)

ON

1 2 3 4

2. Using IR learning, program command “A” from the Video input selection button on the projector’s remote control into memory block #1 of the MLC 52’s Video button as follows:

a. Press the Video button on the MLC front panel. The button blinks, indicating that the MLC is ready to learn the command. On the rear panel, the bottom IR learning LED flashes.

b. Within 5 seconds (while the Video button on the MLC 52 is blinking), press the Video button on the projector’s remote control. The MLC has learned command “A” for video.

When a command has been successfully learned, the IR learning LEDs on the MLC rear panel flash in rapid progression from the top to the bottom, then back to the top.

3. Program the input selection command “A” from the S-video input selection button on the projector’s remote control into memory block #2 of the MLC 52’s Video button as follows:

a. Press the Video button on the MLC front panel. The button blinks, indicating that the MLC is ready to learn the command. On the rear panel, the second LED from the bottom flashes.

4-10 MLC 52 Series MediaLink Controllers • Special Applications