Frymaster BIGLA30 warranty 7.2.2Error Messages and Display Problems, M3000 displays

7.2.2Error Messages and Display Problems

Problem	Probable Causes
M3000 display shows	Frypot temperature is more than 410ºF
hot-hi-1.	(210ºC) or, in CE countries, 395ºF (202ºC).
M3000 display shows	A product cook is started that has a different
REMOVE
DISCARD.	setpoint than the current vat temperature.
M3000 display shows
RECOVERY	Recovery time exceeded maximum time
FAULT and alarm	limit.
sounds.
M3000 display is in
wrong temperature	Incorrect display option programmed.
scale (Fahrenheit or
Celsius).
M3000 display shows
hELP HI-2 or	Failed high limit
High limit
failure.
M3000 display shows	Problem with the temperature measuring
TEMP PROBE	circuitry including the probe or damaged
FAILURE.	computer wiring harness or connector.
M3000 display shows	Gas valve off, failed computer, failed
HEATING
FAILURE.	transformer, open high-limit thermostat.
M3000 displays
SERVICE	An error has occurred which requires a
REQUIRED	service technician.
followed by an error
message.

Corrective Action

Shut the fryer down immediately and call your ASA for assistance.

Remove and discard product. Press the cook button under the display with the error to remove the error. Reset the setpoint of the vat before trying to cook product.

Clear error and silence the alarm by pressing the 9 button. Maximum recovery time for gas is 2:25. If the error continues call your ASA for assistance.

Toggle between F° to C° by pressing and holding 3and4simultaneously until TECH MODE appears. Enter 1658. The computer displays OFF. Turn the computer on to check temperature. If the desired scale is not displayed, repeat.

Shut the fryer down immediately and call your ASA for assistance.

Shut the fryer down and call your ASA for assistance.

It is normal for this message to appear during startup if the lines have air in them. Check that the gas valve is on. If it continues, shut the fryer down and call your ASA for assistance.

Press 8 (2 NO) to continue cooking and call your ASA for assistance. In some cases, cooking may not be allowed.

7.2.3Filtration Problems

PROBLEM	PROBABLE CAUSES	CORRECTIVE ACTION
Fryer filters after each	Filter after setting incorrect.	Change or overwrite the filter after setting
		by re-entering the filter after value in level
cook cycle.
		two. See section 4.13.5 on page 4-33.
MAINT FILTER	Temperature too low.	Ensure fryer is at setpoint before starting
(Manual Filter) won’t
		MAINT FILTER.
start.
M3000 display shows	A. Another filtration cycle or filter pad	A. Wait until the previous filtration
		cycle ends to start another filtration
	change is still in process.
filter busy.		cycle. Change filter pad if prompted.
	B. MIB has not cleared checking system.
		B. Wait one minute and try again.

7-3