Frymaster BIGLA30 warranty Explanation, 7.2.5Bulk Oil System Problems, Corrective Action, Code

Problem Probable Causes

Frypots won’t top off.	A.	Fryer temperature too low.
	B.	Oil is too cold.

C.JIB out of oil (yellow light illuminated)

D.Service required error exists

7.2.5Bulk Oil System Problems

Corrective Action

A. Fryer temperature must be at setpoint.

B.Ensure that the oil in the JIB is above 70°F (21°C).

C.Ensure the JIB is not out of oil. Replace JIB and reset yellow LED. If problem persists call your ASA

for assistance.

D. Call your ASA for assistance.

Problem		Probable Causes		Corrective Action
			A.	Power cycle fryer by disconnecting
				and reconnecting 5-pin control
				power cord.
			B.	If a filtration or any other filter
	A.	Incorrect setup procedure.		menu function is in		process or
				FILTER	NOW?	YES/NO,
	B.	Another function is in process.
JIB won’t fill.				CONFIRM YES/NO, or SKIM VAT
	C.	Dispose valve not completely closed.		are displayed, wait until the process
	D.	Bulk oil tank is empty.
				is complete and try again.
	E.	Solenoid, pump or switch issue.
			C.	Ensure the dispose valve handle is
				pushed fully closed.
			D. Call your bulk oil provider.
			E.	Call you ASA for assistance.
JIB or vat filling slow.	A.	Pump or line issues beyond the scope of	A.	Contact your bulk oil provider.
		operator troubleshooting.
			A.	Power cycle fryer by disconnecting
				and reconnecting 5-pin control
	A.	Incorrect setup procedure.		power cord.
Frypot won’t fill.	B.	Dispose valve not completely closed.	B.	Ensure the dispose valve handle is
	C.	Bulk oil tank is empty.		pushed fully closed.
	D.	RTI pump issue.	C. Call your bulk oil provider.
			D. Call you ASA for assistance.

7.2.6Error Log Codes

Code	ERROR MESSAGE	EXPLANATION
E03	ERROR TEMP PROBE FAILURE	TEMP Probe reading out of range
E04	HI 2 BAD	High limit reading is out of range.
E05	HOT HI 1	High limit temperature is past more than 410°F
		(210°C), or in CE countries, 395°F (202°C)
E06	HEATING FAILURE	A component has failed in the high limit circuit
		such as computer, interface board, contactor or
		open-high limit.
E07	ERROR MIB SOFTWARE	Internal MIB software error
E08	ERROR ATO BOARD	MIB detects ATO board connection lost; ATO
		board failure
E09	ERROR PUMP NOT FILLING	Dirty pad and it needs changed or it was
		bypassed; filter pump problem
E10	ERROR DRAIN VALVE NOT OPEN	Drain valve was trying to open and confirmation
		is missing

7-5