Fujitsu C145-C037-01EN manual Conditions and environment

No.	Item	Specification
19	Paper transport stability (*13)	Paper crease:		single-sided; 1/1,000 sheets
				double-sided; 1/500 sheets
	Notes:
	1) This specification applies to the	Conditions and environment
	recommended paper.	• Printing ratio:			5%
	2) No options	• 23˚C, 50% RH
		• Recommended paper
		Notes:
		1) Paper feeding with the MFF may crease a sheet of paper
			depending on loading conditions.
		2) Light crease having no practical problem (no affect to legibility)
			should not be counted.
		Paper curl:		30 mm or less
		Conditions and environment
		• Printing ratio:			5%
		• 23˚C, 50% RH
		• Recommended paper
20	Electrical	Input voltage			110 to 120 VAC +6%/-10%, 50/60 Hz +2%/-4%
		(*14)			220 to 240 VAC +6%/-10%, 50/60 Hz +2%/-4%
	Notes:
		Input current			9 A or less (120 VAC)
	1) Momentary power failure, AC
					4.5 A or less (230 VAC)
	line noise, pulse noise,
		Power consumption
	momentary variation of supply
		Maximum			700W (at 120 VAC or 230 VAC, excluding inrush
	voltage, antistaic strength,
					current)
	EMC, lightning surge are tested
	by the test printing function	Average			450 Wh or less (at 120 VAC or 230 VAC)
	built in the engine.	during printing
	2) SG and FG are always
		Sleep mode			45 Wh or less (at 120 VAC or 230 VAC)
	connected.
		Insulation resistance					10 MΩ or more with 500 V megger
		(primary-ground)
		Dielectric strength, one minute					1,000 VAC (120 VAC)
		(primary-ground)					1,500 VAC (230 VAC)
		Leakage			0.5 mA or less (at 120 VAC and 60 Hz)
		current			3.5 mA or less (at 230 VAC and 60 Hz)
		Inrush current			90 A or less (at 120 VAC or 230 VAC and 60 Hz)
		(for cold start)
					Applied to first turnig on after leaving power
						turned off more than 12 minutes.
		Momentary			0.5-cycle 100% dip at 120 VAC or 230 VAC (50/
		power failure			60 Hz)
		AC line noise			1 kV or more, pulse width 100 to 800 ns
		Electrostatic strength					9 kV or more
		(conforming to IEC 801-2/91)					150 Ω, 150 pF
							(no mismovement, no misprinting)
		Surge voltage (lightning)						1.2 kV, pulse width: 40 ±8 μs

*12 Do not print on the blank side of used media. It may cause stains on paper and/or decrease of printing capability.

*13 Moistened media may lower toner transferring conditions and paper feeding capability.

*14 The rated voltage of input power differs with countries of destination and their regulations. See Item no. 28.

3-5