5.5.2.2 HP LaserJet 5 HP-GL/2 mode
The
equivalent.
Picture Frame Set Commands |
|
ESC * c # X | Set the horizontal size of the picture frame on the actual physical paper. (#: 1/ |
| 720" increments; 0 to 32767) |
ESC * c # Y | Set the vertical size of the picture frame on the actual physical paper. (#: 1/ |
| 720" increments; 0 to 32767) |
ESC * c # T | Set the anchor point of the picture frame to the current cursor position in PCL6 |
| mode. (#: 0) |
ESC * c # K | Set the horizontal plot size in |
| the picture frame in PCL6 mode to be this size. (#: inches; 0 to 32767) |
ESC * c # L | Set the vertical plot size in |
| picture frame in PCL6 mode to be this size. (#: inches; 0 to 32767) |
ESC * % # B | Enter |
| position is set to the last pen position in the last |
| number = the pen position is set to the current cursor position in the current |
| PCL6 mode) |
ESC * % # A | Enter PCL6 mode from |
| position is set to the last cursor position in the last PCL6 mode, 1 or odd number |
| = the cursor position is set to the current pen position in the current |
| mode) |
Configuration and Status Set Commands
DF | Set defaults to parameters other than scaling points, pen position, pen thickness, |
| pen up/down state, and rotation in |
IN | Set defaults to all parameters to initialize the plotter. |
IP | Set (or input) scaling points P1 and P2 with absolute plotter coordinates. |
IR | Set (or input) scaling points P1 and P2 by the ratios to the picture frame sizes. |
IW | Set (or input) the window area (soft clipping area). |
PG | Advance a full page. Not supported by HP LaserJet 5 |
RO | Rotate the coordinate system in 90 degrees. |
RP | Replot. Not supported by HP LaserJet 5. |
SC | Scaling on/off. Set the user unit coordinate system or reset to the absolute |
| plotter unit coordinate system. |
