■Use the setdscp command with no options (interactive mode).
You are prompted to enter all the DSCP IP addresses sequentially. A command output example of this interactive mode is:
XSCF> setdscp
DSCP network [0.0.0.0] > 10.1.1.0
DSCP netmask [255.0.0.0] > 255.255.255.0 XSCF address [10.1.1.1] > [Enter] Domain #00 address [10.1.1.2] > [Enter] Domain #01 address [10.1.1.3] > [Enter] Domain #02 address [10.1.1.4] > [Enter] Domain #03 address [10.1.1.5] > [Enter] Domain #04 address [10.1.1.6] > [Enter] Domain #05 address [10.1.1.7] > [Enter] Domain #06 address [10.1.1.8] > [Enter] Domain #07 address [10.1.1.9] > [Enter] Domain #08 address [10.1.1.10] > [Enter]
...
Commit these changes to the database (yn)?
i.For each prompt, press the Enter key to accept the displayed value, or type a new value followed by the Enter key.
ii.To save your changes, enter Y. To cancel the changes, enter N.
3.Verify the operation with the showdscp command.
▼To Display DSCP Network Configuration1.Log in to the XSCF console with platadm, platop, or fieldeng privileges, or domainadm, domainop, or domainmgr privileges for a specific domain.
Chapter 3 System Configuration | 29 |