6.3 Power Save

(2) LBA mode

Logical address assignment in the LBA mode starts from physical cylinder 0, physical head 0, and physical sector 1. If the last sector in a zone of a physical head is used, the track is switched and the next LBA is assigned to the initial sector in the same zone of the subsequent physical head.

After the last physical sector of the last physical head is used in the zone, the subsequent zone is used and LBA is assigned from physical head 0 in the same way.

Figure 6.6 shows an example of 4 heads configuration (assuming there is no track skew).

215 216

214 215

215 216

216

217

218

430

431

216

Figure 6.6 Address translation (example in LBA mode)

6.3 Power Save

The host can change the power consumption state of the device by issuing a power command to the device.

6.3.1 Power save mode

There are four types of power consumption state of the device including active mode where all circuits are active.

In the power save mode, power supplying to the part of the circuit is turned off. There are three types of power save modes:

Idle mode

C141-E042-01EN

6-9

Page 150
Image 150
Fujitsu MHA2021AT, MHA2032AT manual Power Save, Power save mode