Fujitsu PCI GigabitEthernet 3.0 status, meaning, parameter

				3.3 Operation Mode Setup
ndd	-set /dev/fjgi 'instance'		value	(Instance number "value" of an applicable
				interface is specified.)
ndd	-set	/dev/fjgi 'param1'	value	(Change 1 of a setup)
ndd	-set	/dev/fjgi 'param2'	value	(Change 2 of a setup)
	:			:
ndd	-set /dev/fjgi 'adv_autoneg_cap'			N (Once let Auto-Negotiation be a different
				value from the present condition.)
ndd	-set	/dev/fjgi 'adv_autoneg_cap'		M (Auto-Negotiation is returned to the
				original value.)

example) While Auto-Negotiation had been enabled, when changing fjgi0 into 100Half (Autonego=1, link_sppd=100, link_mode=0) from a default state (Autonego=1, link_speed=1000, link_mode=1)

# ndd	-set	/dev/fjgi	'instance'	0
# ndd	-set	/dev/fjgi	'adv_1000fdx_cap'		0
# ndd	-set	/dev/fjgi	'adv_1000hdx_cap'		0
# ndd	-set	/dev/fjgi	'adv_100fdx_cap'		0
# ndd	-set	/dev/fjgi	'adv_autoneg_cap'		0
# ndd	-set	/dev/fjgi	'adv_autoneg_cap'		1

(Note) Please perform change and sending back of Auto-Negotiation at the end.

When setting change is reflected (an Auto-Negotiation value being subject to change):

ndd	-set	/dev/fjgi 'instance'	value	(Instance	number "value" of an
				applicable interface is specified.)
ndd	-set	/dev/fjgi 'param1'	value	(Change 1	of a setup)
ndd	-set	/dev/fjgi 'param2'	value	(Change 2	of a setup)
	:			:
ndd	-set /dev/fjgi 'adv_autoneg_cap'			N (Let Auto-Negotiation be a different value
				from the	present condition.)

exapmle) When fjgi0 is changed into the state of 100Full where Auto-Negotiation was

disabled, from the state of 100Half (Autonego=1, link_sppd=100, link_mode=0) where Auto-Negotiation was enabled

# ndd		-set	/dev/fjgi	'instance'	0
#	ndd	-set	/dev/fjgi	'adv_100fdx_cap'		1
#	ndd	-set	/dev/fjgi	'adv_autoneg_cap'		0

(Note) Please make a change of Auto-Negotiation at the end.

● The following parameters can be used with the ndd command:

parameter	status	meaning
?	Read only	Display parameter list

33