Fujitsu PCI GigabitEthernet 3.0 manual 42

3.3 Operation Mode Setup

parameter	status				meaning
		The		link-partner		has	been	set	to
lp_10fdx_cap	Read only	10Mbps/FullDuplex by Auto-Negotiation.
		0	: Invalid
		1	: Valid
		The		link-partner		has	been	set	to
lp_10hdx_cap	Read only	10Mbps/HalfDuplex by Auto-Negotiation.
		0	: Invalid
		1	: Valid
		The		link-partner		has	been	set	to
lp_100fdx_cap	Read only	100Mbps/FullDuplex by Auto-Negotiation.
		0	: Invalid
		1	: Valid
		The		link-partner		has	been	set	to
lp_100hdx_cap	Read only	100Mbps/HalfDuplex by Auto-Negotiation.
		0	: Invalid
		1	: Valid
		The		link-partner		has	been	set	to
lp_1000fdx_cap	Read only	1000Mbps/FullDuplex by Auto-Negotiation.
		0	: Invalid
		1	: Valid
		The		link-partner		has	been	set	to
lp_1000hdx_cap	Read only	1000Mbps/HalfDuplex by Auto-Negotiation.
		0	: Invalid
		1	: Valid
		The link-partner has been set to transmit
lp_pauseTX	Read only	pause frame by Auto-Negotiation.
		0	: Invalid
		1	: Valid
		The link-partner has been set to receive pause
lp_pauseRX	Read only	frame by Auto-Negotiation.
		0	: Invalid
		1	: Valid
		The		link-partner		has	been	set	to
lp_autoneg_cap	Read only	Auto-Negotiate by Auto-Negotiation.
		0	: Invalid
		1	: Valid
		The current Role setting when operating at
		1000Mbps.			(Not		valid		for
role_cap	Read only	PW008GE4/PW0G8GE1/SE0X7GD2X)
		0	: Slave
		1	: Master
jumbo	Read only	0	: JumboFrame support disabled.
		1	: JumboFrame support enabled.

● About speed/duplex/flowcontrol, it recommends carrying out default operation (Auto-Negotiation). In that case, connection partner equipment should also enable

Auto-Negotiation. By doing so, it is the optimal. speed/duplex/flow control It

35