Fujitsu PCI GigabitEthernet 3.0 Cause, Slave, Master, Message, Workaround, Appendix A Messages

Appendix A Messages

No	Message	Cause	Workaround
		[E]
		Master: Communicating as
		Master
		Slave: Communicating as
		Slave
		An error was found with a	Check whether the value
3	Illegal value for [ParameterName].	parameter defined in the	is set correctly in the
		fjgi.conf file.	file.
			Installed physical
			memory may be
4	soft state alloc failed.	Driver internal resources	insufficient. If this is
		cannot be obtained.	not the cause, report
			this error to your
			service provider.
5	Allocation of descriptor memory	The driver could not allocate	Installed physical
	failed	internal resources for DMA.	memory may be
			insufficient. If this is
6	fail to ddi_dma_bind_handle	The driver could not allocate	not the cause, report
		DMA resources.	this error to your
			service provider.
			Re-activate the
		A error was found in message	interface. If this
7	fail to FragCount		message is still
		fragmentation.
			displayed, report to
			your service provider.
		The driver could not allocate	Installed physical
8	Could not allocate DMA handle		memory may be
		DMA resources.
			insufficient. If this is
			not the cause, report
		The driver could not allocate
9	Could not bind descriptor memory		this error to your
		DMA resources.
			service provider.
			Re-activate the
		A error was found in message	interface. If this
10	Multiple fragments in descriptor area		message is still
		fragmentation.
			displayed, report to
			your service provider.
			Installed physical
			memory may be
11	fjgiallocthings failed	The driver could not allocate	insufficient. If this is
		DMA resources.	not the cause, report
			this error to your
			service provider.
			Installed physical
		The driver could not allocate	memory may be
			insufficient or hardware
12	pci_config_setup_failed	sufficient PCI configuration
			has failed. Report this
		space.
			error to your service
			provider.

60