Fujitsu S300M 2.2Connecting the ScanSnap to Your Computer, CAUTION, ■Connecting the cable

2.2Connecting the ScanSnap to Your Computer

2.2Connecting the ScanSnap to Your Computer

When the installation of the above programs is complete, connect the ScanSnap to your computer.

ATTENTION	Be sure to install the supplied programs, and then restart your computer before
	connecting the ScanSnap to your computer with cables. (For details about the
	installation, refer to "2.1 Installing ScanSnap" (page 6).)

■Connecting the cable

Connect the ScanSnap to a power supply in either of two ways below:

First, connect to a power supply, and then connect to your computer with the USB cable.

Power source			Use the following cable:	See:
Power outlet			Power cable	"When connecting with the
(When always operating				power cable:" (page 16)
the ScanSnap at the
same regular place			The power cable is
where it can be fed
power from a power			a combination of
			the AC adapter
outlet)
			and cable.
Computer				"When connecting with the
			USB bus power	USB bus power cable:" (page
(When using the				17)
			cable
ScanSnap at a place
where it reaches no
power outlet, or when
carrying the ScanSnap
together with your laptop
computer around and
operating at a place
where no power outlet is
available)
	Use only the AC cable and AC adapter (power cable) below:
CAUTION	Otherwise, a failure may be caused.
	•	Manufacturer: LEI
	•	Model No.: NU13-1072166-I3

2

ScanSnap Connecting

ScanSnap S300M Operator's Guide 15