Fujitsu Siemens Computers X103 SFF instruction

Image 46

Fujitsu Siemens Computers X103 SFF manual

Contents

Edition X103 SFF Are there Page Published by Edition X103 SFF Operating ManualPage Contents Contents Your Edition X103 SFF Notational conventionsPage Important notes Safety notesCleaning the device Transporting the device CE marking Energy saving, disposal and recyclingCE marking for devices without radio component Unpacking and checking the delivery Steps for initial setupPreparing for use External devices Setting up the device Vertical operating position Connect the monitor, mouse and keyboard Horizontal operating position with rubber feet Connecting the mouse Connecting the monitorConnecting a keyboard Connecting the device to the mains voltage Initial switch-on Software will be installed Installing the software Connecting external devicesSwitching on monitor and device Connecting cables Disconnecting cables Ports provided by the device Port settings Connecting external devices to the parallel or serial portConnecting external devices to the USB ports Device driversPage Switching off the device Switching the device onOperation Floppy disk indicator Indicators provided by the deviceDrive indicator, e.g. DVD Hard disk indicator Important keys and key combinations ON/OFF switch optionalKeyboard Enter key Shift key Warm bootMenu key Alt Gr e.g. German keyboard Settings in Bios Setup Working with floppy disksPage Mains voltage supply is faulty Troubleshooting and tipsInstalling new software Internal power supply overloaded Device cannot be switched off with the ON/OFF switch Screen stays blank Wrong monitor has been set under Window XP No mouse pointer displayed on the screenFloppy disk cannot be read or written Wrong RAM modules have been inserted Time and/or date is not correct Error messages on the screenRestoring the hard disk contents Tips System expansions Information about boards Opening the casing Opening and closing the casingClosing the casing Removing the holding plate Installing a boardAssembling and dismantling low-profile units Removing a board Removing the cross-piece Inserting and removing the drive cageRemoving the drive cage Removing the front panel Disconnecting cables Removing the drive cage Installing the drive cageAttaching the drive cage System expansions Installing the cross-piece Installing and removing drivesIDE drives and serial ATA drives Removing and installing accessible drives Installing and removing the hard disk System expansions Making changes on mainboard Replacing lithium batteryExtensions to the mainboard Upgrading main memory Following changes Page Weight Technical dataDimensions Electrical dataPage Cable IndexData Index Scsi