Removing the holding plate

System expansions

Assembling and dismantling low-profile units

	!	Do not dispose of the slot cover. If you remove the board again, you must reinstall the slot
	!	cover (cooling, fire protection or EMC regulations to be complied with).

►Open the casing (see "Opening the casing").

►Undo the screws (1) and remove the holding plate (2).

Installing a board

►Push the board up to its slot as far as the stop.

►Press the board into the slot so that it engages.

►If necessary, plug the lines on the board again.

Removing a board

►Disconnect the cables connected to the board.

►Pull the board out of the slot.

Re-assembling the holding plate

►Position the holding plate (2) so that it secures the components.

►Screw in the screws (1) previously removed again.

VFY-SCED103S, edition 1

Page 35

Image 35

Contents

Edition X103 SFF Are there Page Published by Operating Manual Edition X103 SFFPage Contents Contents Notational conventions Your Edition X103 SFFPage Transporting the device Safety notesCleaning the device Important notes CE marking for devices without radio component Energy saving, disposal and recyclingCE marking External devices Steps for initial setupPreparing for use Unpacking and checking the delivery Setting up the device Vertical operating position Horizontal operating position with rubber feet Connect the monitor, mouse and keyboard Connecting a keyboard Connecting the monitorConnecting the mouse Initial switch-on Software will be installed Connecting the device to the mains voltage Connecting cables Connecting external devicesSwitching on monitor and device Installing the software Ports provided by the device Disconnecting cables Device drivers Connecting external devices to the parallel or serial portConnecting external devices to the USB ports Port settingsPage Operation Switching the device onSwitching off the device Hard disk indicator Indicators provided by the deviceDrive indicator, e.g. DVD Floppy disk indicator Enter key ON/OFF switch optionalKeyboard Important keys and key combinations Alt Gr e.g. German keyboard Warm bootMenu key Shift key Working with floppy disks Settings in Bios SetupPage Internal power supply overloaded Troubleshooting and tipsInstalling new software Mains voltage supply is faulty Screen stays blank Device cannot be switched off with the ON/OFF switch Wrong RAM modules have been inserted No mouse pointer displayed on the screenFloppy disk cannot be read or written Wrong monitor has been set under Window XP Tips Error messages on the screenRestoring the hard disk contents Time and/or date is not correct Information about boards System expansions Closing the casing Opening and closing the casingOpening the casing Removing a board Installing a boardAssembling and dismantling low-profile units Removing the holding plate Removing the front panel Inserting and removing the drive cageRemoving the drive cage Removing the cross-piece Attaching the drive cage Installing the drive cageDisconnecting cables Removing the drive cage System expansions IDE drives and serial ATA drives Installing and removing drivesInstalling the cross-piece Installing and removing the hard disk Removing and installing accessible drives System expansions Upgrading main memory Replacing lithium batteryExtensions to the mainboard Making changes on mainboard Following changes Page Electrical data Technical dataDimensions WeightPage Data IndexCable Index Scsi

Fujitsu Siemens Computers X103 SFF Assembling and dismantling low-profile units, Removing a board

Models: X103 SFF

Assembling and dismantling low-profile units