Installing and removing drives

System expansions

Installing the cross-piece

1		1

►Place the cross-beam (2) in the casing and secure it with the two screws (1). Make sure that the screw holes are exactly aligned. Otherwise, turn the cross-beam over.

►Close the casing (see "Closing the casing").

In the standard model the device may be equipped with the following drives:

●one accessible 3 ½ inch drive (floppy drive)

●one non-accessible 3 ½ inch drive (floppy drive)

●one accessible 5 ¼ inch drive (e.g. DVD or CD ROM drive)

IDE drives and serial ATA drives

IDE drives and serial ATA drives are supported by default.

VFY-SCED103S, edition 1

Page 39

Image 39

Fujitsu Siemens Computers X103 SFF manual Installing and removing drives, Installing the cross-piece

Contents

Edition X103 SFF Are there Page Published by Operating Manual Edition X103 SFFPage Contents Contents Notational conventions Your Edition X103 SFFPage Transporting the device Safety notesCleaning the device Important notes Energy saving, disposal and recycling CE markingCE marking for devices without radio component External devices Steps for initial setupPreparing for use Unpacking and checking the delivery Setting up the device Vertical operating position Horizontal operating position with rubber feet Connect the monitor, mouse and keyboard Connecting the monitor Connecting the mouseConnecting a keyboard Initial switch-on Software will be installed Connecting the device to the mains voltage Connecting cables Connecting external devicesSwitching on monitor and device Installing the software Ports provided by the device Disconnecting cables Device drivers Connecting external devices to the parallel or serial portConnecting external devices to the USB ports Port settingsPage Switching the device on Switching off the deviceOperation Hard disk indicator Indicators provided by the deviceDrive indicator, e.g. DVD Floppy disk indicator Enter key ON/OFF switch optionalKeyboard Important keys and key combinations Alt Gr e.g. German keyboard Warm bootMenu key Shift key Working with floppy disks Settings in Bios SetupPage Internal power supply overloaded Troubleshooting and tipsInstalling new software Mains voltage supply is faulty Screen stays blank Device cannot be switched off with the ON/OFF switch Wrong RAM modules have been inserted No mouse pointer displayed on the screenFloppy disk cannot be read or written Wrong monitor has been set under Window XP Tips Error messages on the screenRestoring the hard disk contents Time and/or date is not correct Information about boards System expansions Opening and closing the casing Opening the casingClosing the casing Removing a board Installing a boardAssembling and dismantling low-profile units Removing the holding plate Removing the front panel Inserting and removing the drive cageRemoving the drive cage Removing the cross-piece Installing the drive cage Disconnecting cables Removing the drive cageAttaching the drive cage System expansions Installing and removing drives Installing the cross-pieceIDE drives and serial ATA drives Installing and removing the hard disk Removing and installing accessible drives System expansions Upgrading main memory Replacing lithium batteryExtensions to the mainboard Making changes on mainboard Following changes Page Electrical data Technical dataDimensions WeightPage Index CableData Index Scsi

Fujitsu Siemens Computers X103 SFF Installing and removing drives, Installing the cross-piece

Models: X103 SFF

System expansions

Installing the cross-piece

Installing and removing drives

IDE drives and serial ATA drives