Gateway 980 manual

www.gateway.com

56

Follow the instructions in “Closing the server case” on page 32.

7

- OR -

If you are replacing a voltage regulator, on each end of the voltage regulator support bracket, pinch the sides together, then lift the bracket away from the server. You may need to first remove a heat sink or some memory modules in order to access the sides of the support bracket.

4 Lift the voltage regulator away from the system board.

5 Insert the new voltage regulator into the voltage regulator slot, then replace the support bracket.

6 If you removed a heat sink or some memory modules in Step 3, replace them.

Follow the instructions in “Opening the server case” on page 28. If you are installing a new voltage regulator, go to Step 5.

2

3

Chapter 4: Installing Components

Installing a voltage regulator

To install a voltage regulator:

1 Follow the instructions in “Preventing static electricity discharge” on page 27.