Gateway ALR 8300 manual 102

Error Message	Solutions
Keyboard controller failure.	Try a working keyboard.
	Make certain the keyboard is compatible with
	the system. You may have to change the
	switch setting to AT.
	Replace the keyboard chip.
Keyboard controller failure.	Try a working keyboard.
	Make certain the keyboard is compatible with
	the system. You may have to change the
	switch setting to AT.
	Replace the keyboard chip.
Keyboard not detected.	See “The keyboard doesn’t work.” on
	page 85.
	Turn off the system and check the keyboard
	cable.
Keyboard stuck key failure.	Remove any objects that may be resting on
	the keyboard, and then restart the system.
	Check for sticky keys. Clean the keyboard if
	necessary.
Memory errors were	See “Memory errors were detected during
detected while the system	system start up.” on page 81.
powered up.
Memory size error.	Enter BIOS Setup and save the memory
	configuration.
Non-system disk or disk	Eject the diskette and press ENTER.
error.	If the diskette is bootable, check it for errors.
Not enough memory.	Close all programs not currently in use.
Print queue is full.	Wait until the current print job has completed
	before sending another print job.
	If you receive this error often, you need to add
	memory to the printer.
Printer is out of paper.	Add paper to the printer.
	Make certain the printer is online.
Required parameter	Make certain you entered the right command.
missing.	If you are trying to exit MS-DOS to return to
	Windows, type ANEJ and press ENTER.
Syntax error.	Make certain you entered the right command.
	If you are trying to exit MS-DOS to return to
	Windows, type ANEJ and press ENTER.
Time and date not set.	Enter BIOS Setup to set the system date and
	time.
Write protect error.	Move the write-protection tab over the hole on
	the back of the diskette.

90 Maintaining and Troubleshooting the Gateway ALR 8300 Server