3.Wearing an anti-static wristband grounded to the system chassis, remove the lock bar from the processor support. See Figure 9.

Figure 9: Removing the Lock Bar

4.Remove the two screws that secure the processor cartridge in the supports and remove the lock bar.

5.Lift the processor cartridge straight up and away from the system board. See Figure 10.

Figure 10: Removing the Processor Cartridge

Important!

If the error message “update table not found for CPUxx, Stepping xxxx” displays at boot up, run the MULOADER utility located on the disk included with your processor kit. This message may occur under the following conditions: When a new processor has been added that does not include the stepping information in the table. When the BIOS is flashed, it may remove the stepping information form the table which will cause the error message to appear.

Installing Components 27