Replacing a RAID drive

The hard drives in the RAID bay are secured to guide rails, which lets you install and remove the drives from the system chassis. Use this procedure for the SCA SCSI drives installed in the RAID bay, not the 3.5-inch drive bay at the back of the chassis. The RAID bay supports up to six 3.5-inch LVD SCA SCSI hard drives

To Replace a RAID Drive

1.Unlock and open the lower bezel door.

2.Locate the SCA hard disk that you want to replace.

3.Pull the release latches on the guide rails outward to release the drive from the RAID bay (see Figure 22).

Figure 22: Removing an SCA Drive

4.Pull the drive straight out of the bay.

Installing Components 43