Gateway ALR 9200 Reinstall the foam cover, 15.Reinstall the foam cover, Close the case, as described in, Figure 10: Installing a Processor

SEC cartridge

Retention module guide rail

Tab on SEC cartridge

Processor heat sink (must face away from the system board)

Figure 10: Installing a Processor

13.When the cartridge meets resistance, push the two tabs toward each other (Figure 10) until the processor is fully seated.

14.Reattach the retention module bracket:

a.With the bracket in an open position (perpendicular to the front of the retention module), slide the open hinge at the left of the bracket into its receptacle at the left of the retention module.

b.Rotate the bracket to the right until it reaches the retention module. With your right thumb on the face of the bracket and your right index finger around the tab at the right of the bracket, slightly pull the tab outward and to the left to open the latch at the back of the tab.

c.As you open the latch on the back of the tab, slide the right edge of the bracket onto the retention module and release the tab. If done correctly, the bracket will latch securely.

15.Reinstall the foam cover.

16.Close the case, as described in “Closing the System” on page 7.

17.Reconnect the power cord and turn on the system.

Note:

The foam cover is required to control airflow past the processors for proper cooling. Failure to install the foam cover could result in damage to the processors and other system components.

Installing Another Processor 39