8.Pull the two tabs attached to the termination module (visible after you remove the bracket—C in Figure 9) straight away from the system board. As you do, the termination module disengages from the connector on the system board.

Tab on retention module

Retention module guide rail

Termination module

Retention module guide rail Tab on retention module

Figure 9: Removing the Termination Module

9.Slide the termination module straight away from the system board, out of the retention module. Put it on a piece of conductive foam and store it in an antistatic package.

10.Remove the processor cartridge from its protective wrapping.

11.Orient the S.E.C. cartridge so that the heat sink faces away from the center of the system board.

12.With the tabs at the top of the S.E.C. cartridge completely open (pulled outward, away from the center of the cartridge, Figure 10), slide the cartridge into the guide rails of the retention module (Figure 10). When done properly, the triangular ends of the tabs (with two round pegs on each) fit into the entrance to the guide rails.

38 Maintaining and Troubleshooting the Gateway ALR 9200 Server