Gateway ALR 9200 To Install the Memory Module, Run the SSU (see, Installing the Memory Module, 7.Reinstall the foam cover(s), Reinstall the memory module (see

Note:

DIMM slots on the memory module must be installed only in certain configurations. See “Memory Configuration” on page 25 for requirements.

Caution!

The memory module is held in place by the 242-pin connector on the system board, the guide rail at the back of the electronics bay, and a plastic guide at the front of the electronics bay. You must support the module until it is fully seated in the connector.

4.Push the ejector levers on the socket ends to the upright position.

5.Repeat steps two through four to install each DIMM.

6.Reinstall the memory module (see “Installing the Memory Module” on page 44).

7.Reinstall the foam cover(s).

8.Reinstall the access cover using the original screws.

9.Connect all external cables and the power cords to the system.

10.Turn on the monitor and then the system.

11.Run the SSU (see “Resource Configuration Add-in Window” on page 112) to configure the system and to properly attribute ECC memory.

Installing the Memory Module

Once you have installed any DIMMs that you want, you must re-install the memory module.

To Install the Memory Module

1.Observe the safety and ESD precautions in “Static Electricity Precautions” on page 2.

2.Holding the memory module by its edges, align the module so its edge engages in the guide rail at the back of the electronics bay.

3.Push the memory module toward the system board until it fully engages its connector.

4.Install the foam pad in the electronics bay.

5.Replace the system access cover and screws.

44 Maintaining and Troubleshooting the Gateway ALR 9200 Server