Gateway ALR 9200 Removing DIMMs, Figure 11: Removing the Memory Module, 5.Place the module component-sideup on a nonconductive, static-freesurface

4.Remove the memory module from the system board by pulling it gently from the electronics bay (see Figure 11). It is not necessary to open the electronics bay to remove the memory module.

Figure 11: Removing the Memory Module5.Place the module component-side up on a nonconductive, static-free surface.Removing DIMMs

When adding and removing DIMMs, remember that DIMMs must be installed or removed by banks. Each bank consists of four DIMM sockets. All DIMMs in the bank must be installed and all must be of the same size and speed. See Figure 4 on page 23 for the location of the DIMM sockets in each bank.

Installing Hardware 41