Gateway ALR 9200 Figure 2: Opening the Subchassis and Electronics Bay, 10.Disconnect all cabling to the electronics bay (D in Figure 2)

Caution!

You must disconnect all cabling to the electronics bay before rotating/ removing the bay. Failure to do so can result in serious damage to system components. The location of the main connectors in the electronics bay is marked as D in Figure 2.

Note:

It may be easier to disconnect the cables if you remove the foam pad first.

8.Loosen the two screws on the top and bottom edges of the chassis (A in Figure 2). These screws attach the front subchassis and the electronics bay to the main chassis.

A

B

C

D

Figure 2: Opening the Subchassis and Electronics Bay

9.Using the edges of the subchassis as handles, rotate the front subchassis left, away from the main chassis, until it stops (B in Figure 2).

10.Disconnect all cabling to the electronics bay (D in Figure 2).

11.Using the vertical edge of the electronics bay as a handle, rotate the bay right, away from the main chassis, until it stops (C in Figure 2).

12.If necessary, completely remove the subchassis and electronics bay: rotate the bays outward until the two pins that function as hinges for the bays slide out of their slots. Set the bays aside.

6 Maintaining and Troubleshooting the Gateway ALR 9200 Server