GE GE-DS-82, 82-POE LED Indications, Gigabit TP Interface, Gigabit SFP Slots, Reset button

Chapter 2: Installation

Gigabit TP Interface

Port-9, Port-10: 10/100/1000Base-T Copper, RJ-45 Twist-Pair: Up to 100 meters.

Gigabit SFP Slots

Port-9, Port-10: 1000Base-SX/LX mini-GBIC slot, SFP (Small Factor Pluggable)

transceiver module: From 550 meters (Multi-mode fiber), up to 10/30/50/70/120 kilometers (Single-mode fiber).

Reset button

At the left of front panel, the Reset button is designed to reboot the Managed Switch without turning the power off. The following table summarizes the Reset button functions:

Reset Button Pressed and Released	Function
About 1-3 seconds	Reboots the Managed Switch
	Resets the Managed Switch to Factory Default configuration.
	The Managed Switch will then reboot and load the default
	settings as below:

Until the PWR LED goes out	•	Default Password: admin
	• Default IP address: 192.168.0.100
	•	Subnet mask: 255.255.255.0
	•	Default Gateway: 192.168.0.254

LED Indications

The front panel LEDs provide instant status of port links, data activity and system power. They help monitor the system and aid in troubleshooting when necessary. The front panel LEDs are shown in Figure 2.

Figure 2: GE-DS-82 LED panel

12 GE-DS-82 and 82-PoE Ethernet Managed Switch User Manual