GE GE-DS-82, 82-POE Switch Rear Panel, Per 10/100Base-TX, PoE interfaces Port-1 to Port-8

Chapter 2: Installation

•Per 10/100Base-TX, PoE interfaces (Port-1 to Port-8)

LED	Color	Function
		Lit: indicates the link through that port is successfully
LNK/ACT	Green	established
		Blink: indicates the Switch is actively sending or receiving data
		over that port
		Lit: indicates the port is providing 48VDC in-line power
PoE In Use	Orange	Off: indicates the connected device is not a PoE Powered
		Device (PD)

•Per 10/100/1000Base-T port/SFP interfaces

LED	Color	Function
		Lit: indicates the port is operating at 1000Mbps
LNK/ACT 1000	Green	Off: indicates the port is operating at 10Mbps or 100Mbps
		Blink: indicates the Switch is actively sending or receiving data
		over that port
		Lit: indicates the port is operating at 100Mbps
LNK/ACT 100	Green	Off: indicates the port is operating at 10Mbps or 1000Mbps
		Blink: indicates the Switch is actively sending or receiving data
		over that port

NOTE:

1.Press the RESET button once. The Switch will reboot automatically.

2.Press the RESET button for about 10 seconds. The Switch will revert to the factory default mode; the entire configuration will be erased.

3.The 2 Gigabit TP/SFP combo ports are shared with port 9/10 of GE-DS-82 / GE-DS-

82-PoE. Both of them can operate at the same time.

Switch Rear Panel

The rear panel of the Managed Switch includes an AC inlet power socket, which accepts input power from 100 to 240VAC, 50-60 Hz. Figure 4 shows the rear panel of the Managed Switch.

14 GE-DS-82 and 82-PoE Ethernet Managed Switch User Manual