How to hseti the Module
1.Be sure the controls are turned to 0~. To install the module, position the plug to the outside wdl of the cooktop.
2.Slide the modtie toward the outiet in the side of the cooktop until the plug is pushed dl the way in.
3.Lower the inside edge of the module into the cooktop untti it is flush with the cooking surface.
How to Remove the Module
1.Be sure the controls are turned to 0~ and the radiant surface units are cool before attempting to remove the module.
2.Lift up the tab at the inside edge of the module until the base clears the opening at the side of the cooktop.
3.To unplug, hold the module by the front and back edges and slide toward the center of the cooktop. Lift out when unplugged.
4. If you are storing modules, do not stack them or | — |
store other matends on top of them. This could |
|
damage the surface of the modties. |
|
&neml Information About Radiant Modules
The radiant module features heating coils beneath a smooth glass @rarnic surface. The two surfaces units are shown by outiines on the glass.
●When a surface unit is activate& cofls beneath the surface unit radiate heat through the glass to the mohare. The red glow of the cofis wdl be instantly visible through the glass. It wi~ take the surfam unit a few moments to heat up. The cofi cycles on and off to maintain your selected control setting. The coils have temperature limiters to prevent runaway temperatures.
●Use the same cookware that you would use with solid disk surface units.
●If you are storing modules, do not stack them or store other matends on top of them as damage to the glass ceramic surface of the radiant module is likely. Be careful not to damage or bend the electrid plug.
●Do not let pots boil dry. Overheated metal can bond to glass module. A overheated copper pot wfil leave a residue that will permanently stain the modde.
●Sliding rdurninum cookware across the glass may leave meti marks. These meti marks wfll appear as small scratches. They can be removed with Cook Top Cleaning Creme and a razor scraper.
●When a surface unit is turned on, the surface unit can be seen glowing red within a few semnds. The red @ow will turn on and off (cycling) to maintain the selected heat setting. With poor cookware, you wdl see frequent cycling of the unit off and on. Goo@ flat cookware will minimize the cycling.
●It is safe to place hot cookware from the oven or surface on the glass ceramic surface when the surface is cool.
—
16
