GEAppliances.com

Safety

Extension Rack

When placing and removing cookware, always pull the rack out by its upper front rail to its fully open position.

NOTE: Do not extend the rack quickly. Food may slide off the front of the rack.

To replace the rack:Firmly grasp both sides of the rack frame and the sliding rack.

Place the curved end of the rack (stop-locks) onto the oven supports, tilt up the front of the rack and push it in as far as it will go.

Operating Instructions

Upper Front Rail

Fully Open Position

To remove the rack:Make sure the rack is pushed all the way into the oven.

Pull both release levers toward the front of the rack, hold them and slide the rack toward you to the bump (stop position) on the rack support.

Release Levers

Firmly grasp both sides of the rack frame and the sliding rack, tilt the front end up and pull it out.

CAUTION: Never use the rack when its frame is not fully inserted in the oven and locked into position.

■When the rack is properly installed and locked into position, the locking side paddles on the rack frame will click-lock into place on the oven supports. If the side paddles did not click-lock into position, repeat the steps above and make sure the side paddles have been correctly cleaned and lubricated. See Extension Rack in the Care and cleaning section.

■Do not place the extension rack in the highest position in the oven.
Consumer Tips Troubleshooting Cleaning and Care Instructions

Grasp here

 

NOTE: When handling the extension rack,

 

do not allow the sliding portion to fall open.

7

This can damage the slides.
Support