7Installation
Step (continued)
Jo~n@multiple
cooktops
Remove —
These Nuts
Cooktop
Joiner Strip H
D/agram57 7
Ifavailable, an assisrant can ease the installation process. “Place flanged nuts in end of 5/16“ nutdriver. From
“Using alarge, solid work surface, lay cooktops upside under counter, start nuts on studs and tighten.
down on soft, clean towel.
.Remove endcaps on sides to bejoined by removing
three nuts with 5/ 16“ nutdriver. Discard nuts.
.Attach joiner strip to first cooktop using nuts with
flanges and tighten.
-Place the two cooktops in countertop cutout.
-Slide the two cooktops together so that the slots in the
joiner strip are engaged by the studs, and no gaps are
between cooktops and joiners.
Note: Firmly press two cooktops
together against joiner strip to
assure tight fit.
Attachin~ When attaching gas to gas, gas to Halogen, Halogen to
chassiss;’oti Halogen, orgrill to grill, place support brace as shown.
braceto One brace supplied with each component.
.Remove one screw from center of each cooktop chassis.
equal-height -Position brace and retighten screws.
cookt@s
(Repeat above steps for three cooktops.)
gram 512
Attaching When attaching grill to Halogen/Radiant or gas, place
chassissu~ort support brace asshown.
braceto .Remove one screw from center of each cooktop chassis.
d~jment-height .Position brace and retighten screws.
cookto@ (Repeat above steps for three cooktops.)
hagrarn573
51