Installation
Component Cooking Surfaces
7Installation
Step (continued)
Jo~nW
cooktq ~“ Note:To prevent knobs being
downdrafi scratched, knobs must be
vent removed from component before
it isturned upside down.
D/agram521
.Remove all grates, knobs, burner caps, drip pans, etc.
Lay cooktop upside down on soft, clean towel on a
large work surface.
sRemove endcap on side ofcooktop to bejoined by
removing three nuts with 5/ 16“ nutdnver. Discard nuts.
Important: Pre-tap holes in downdraft joiner and
endcaps by driving supplied screws through holes and
then backing out before installation. This will facilitate
thejoining process later on.
-Replace endcap with downdraftjoiner strip using the
same three nuts.
Attach downdraft endcap to appropriate side of
downdraft vent ifvent is at end of acooktop run.
-Place downdraft vent and cooktop in countertop

%)

i
cutout. D/agram522
Attach one downdraft vent housing support brace
to front of unit.
.Remove two screws from front of cooktop chassis.
.Put brace in place on cooktop first, using two removed
screws. Thread asimilar screw, provided, through
plenum.
Q-
.Drive two Phillips-head screws into holes inside top of
downdraft vent using Phillips screwdriver bit socket.
.Ifdowndraft vent is installed at end of configuration,
secure downdraft endcap by driving two Phillips head
screws, as shown. Diagram 523
.To finalize installation, proceed to “Securing
cooktop(s) to countertop.
-Ifadditional cooktop(s) are to be installed, proceed to
“Joining additional cooktop to other side of downdraft Frontof Countertop
vent.
Downdraft Endcap
D:agram524
52