Remote Control Kit Installation

Component Cooking Surfaces
Accessorykit
installation
(continued)
D/agram 601
“Remove grate and knobs.
“Detach control box from front of downdraft vent or
downdraft grill by removing the two screws with a
Phillips screwdriver, and the shaft nut with a9/ 16“
deepwell socket.
Frontof
Countertop
Confirm remote control location by initial routing of
cable to assure sufficient length and bend capability.
-Drill holes:
–Wood must be 3/4” thick; shim or rout if necessary
to achieve this dimension.
“Align (arrow points up) and insert control knob
escutcheon into hole in cabinet front.
-Route cable and control box to back side of drilled
holes.
“Align control box (flange at top) to escutcheon.
“Re-use shaft nut to fasten escutcheon to control box
with a9/16“ deepwell socket wrench.
.Place knob supplied with kit on control shaft.
.Place grate supplied with kit over vent opening.
.Store original grate and knobs for optional future use.
Follow same procedure for countertop installation.
Dtagram 60.2
1J
Dtagram 60.3
60