Genicom GEK 00031B manual ESC \ n1 n2

ESC \ n1 n2	Set Relative Print Position: Sets the position where printing will
	occur next relative to the current print position. Parameters n1 and
	n2 are in 1/120-inch increments and are expressed as n1 + (n2 x
	256). Parameter limits for n1 and n2 are 0-255.
	Example 1: If you want to move 4 inches to the right, then:
	4 x 120 = 480 (total number of 1/120-inch increments
	480/256 = 1 with a remainder of 224
	n1 = 224
	n2= 1
	Expressed In BASIC, this is:
	CHR$(27);CHR$(92);CHR$(224);CHR$(1);
	Example 2: If you want to move 4 inches to the left, then:
	65,536 - 480 = 65,056
	65,056/256 = 254 with a remainder of 32
	n1 - 32
	n2 – 254
	Expressed in BASIC, this is:
	CHR$(27);CHR$(92);CHR$(32);CHR$(254);
	Decimal:		27 92 (n1) (n2)
	Hex:		1B 5C (n1H) (n2H)
	BASIC:		CHR$(27);CHR$(92);CHR$(n1);CHR$(n2);
ESC s n	Turn Half-Speed Print Mode ON/OFF: Turns the half-speed print
	mode on or off according to the value of the parameter n below. Half
	speed printing is accomplished by only printing when the shuttle is
	moving from right to left.
	n=1	half-speed on
	n=0	half-speed off
	Decimal:		27 115 n
	Hex:		1B 73 nH
	BASIC CHR$(27);"s";CHR$(n);

Chapter 6. Epson FX286-E Emulation 140 GEK-00029A