Genicom GEK 00031B manual Set Line Spacing 7/72 Inch Set Line Spacing n/72 Inch, Format

Set Line Spacing 7/72 Inch

Set Line Spacing n/72 Inch

Specifies the line spacing at 7/72-inch (10.3 lpi) increments.

Format
<SFCC> 1
Decimal:	<SFCC> 1
Hex:	<SFCC> 31
BASIC:	CHR$(<SFCC>);”1”;
Details

When the 7/72-inch line spacing control code is received, all lines print at the 7/72-inch line spacing until a new line spacing is selected or power is reset.

Indeterminate Conditions

Overlapping lines may occur when combining this control code with other print attributes such as Elongated (Double High), Superscript, or Subscript;

Stores a line spacing of n/72-inch increments.

Format

<SFCC> A <n>	followed by
<SFCC> 2
Decimal:	<SFCC> 65 <n>	followed by
	<SFCC> 2
Hex:	<SFCC> 41 <nH>	followed by
	<SFCC> 2
BASIC:	CHR$(<SFCC>);”A<n>”;	followed by
	CHR$(<SFCC>);”2”;

n = 1 to 24 (all others are ignored)

Details

When the SFCC A control sequence is received, all line feed commands following an SFCC 2 sequences are at n/72-inch line spacing until a new line spacing is selected or power is reset.

The SFCC 2 sequence asserts the line spacing that was stored by the preceding SFCC A sequence.

Indeterminate Conditions

Small values of n may result in overlapping lines. Overlapping lines may also occur if print attributes such as Elongated (Double High), Superscript, or Subscript characters are used on the same line.

Printing at different horizontal and vertical densities will not overlap.

Chapter 4. Printronix P Series Emulation 96 GEK-00029B