Genicom GEK 00031B manual Ssu, Shs, Svs

SSU	Select Size Unit: When PUM is set, Select Size Unit selects either
	decipoints or pixels as the spacing unit, depending on the parameter
	settings defined below.
	If the printer receives an SSU while PUM is reset, the selected unit
	will take effect when PUM is set and will then remain in effect until
	the printer receives another SSU or a reset sequence. Default value at
	power-up or reset is decipoints. The printer will ignore all Ps values
	other than 2 or 7.

General Command Syntax

ESC [ Ps SP I
Decimal:	27 91 Ps 32 73
Hex:	1B 5B Ps 20 49
BASIC:	CHR$(27);”[“;Ps;” I”;

Ps Spacing Unit

2Decipoint (1/720 inch)

7Pixel (1/600 inch)

SHS	Select Horizontal Spacing: Ps selects the horizontal pitch.
	General Command Syntax
	ESC [ Ps SP K
		Ps	Horizontal Pitch
		0	10 characters per inch
		1	12 characters per inch
		2	15 characters per inch
		3	6 characters per inch

	Decimal:	27 91 Ps 32 75
	Hex:	1B 5B Ps 20 4B
	BASIC:	CHR$(27);”[“;Ps;” K”;
SVS	Select Vertical Spacing: Ps selects the vertical spacing between
	lines that is used by all fonts.
	General Command Syntax
	ESC [ Ps SP L
			Ps	Vertical Pitch
			0	6 lines per inch
			1	4 lines per inch
			2	3 lines per inch
			3	12 lines per inch
			4	8 lines per inch
			5	5 lines per 30 inches
			9	2 lines per inch
			1	10 lines per inch
	Decimal:	27 91 Ps 32 76
	Hex:	1B 5B Ps 20 4C
	BASIC:	CHR$(27);”[“;Ps;” L”;

GEK-00029A 177 5000 Series Programmer’s Manual