Genicom GEK 00031B manual Margins, ESC C NUL n

MARGINS

ESC C n	Set Page Length in Lines: Sets the forms length to n lines. The
	value for form length is stored in inches and will not change when
	line spacing Is changed. This sequence resets the top of form value to
	the current line position and resets the perforation skip mode. Form
	lengths of zero or greater than 22 inches are ignored and leave the
	existing form unchanged. The parameter limits are 1-255.
	Decimal:	27 67 n
	Hex:	1B 43 nH
	BASIC:	CHR$(27);"C";CHR$(n);
ESC C NUL n	Set Page Length in Inches: Sets the forms length from 1 to 22
	inches depending on the value for the parameter n. This sequence
	resets the top of form value to the current line position and resets the
	perforation skip mode. Form lengths of zero or greater than 22
	inches will be ignored and leave the existing form unchanged. The
	parameter limits are 1-255.
	Decimal:	27 67 0 n
	Hex:	1B 43 00 nH
	BASIC:	CHR$(27);"C";CHR$(0);CHR$(n);
ESC N n	Set Skip Over Perforation: Sets a bottom margin region to avoid
	printing on the perforation when using continuous forms. The
	parameter n determines the number of print lines to be included in
	the skip area. This is converted to an absolute distance in inches
	based on the current line spacing value. Subsequent changes to the
	line spacing will not automatically change this setting. When form
	length is changed (by ESC C NUL n or ESC C n), the skip perforation
	is cleared. If the skip value exceeds the form's length, it is ignored. A
	parameter value of zero leaves the previous setting unchanged.
	Decimal:	27 78 n
	Hex:	1B 4E nH
	BASIC:	CHR$(27);"N";CHR$(n);
ESC 0	Cancel Skip Over Perforation: Resets the skip perforation value to
	zero.
	Decimal:	27 79
	Hex:	1B 4F
	BASIC:	CHR$(27);"O";

Chapter 6. Epson FX286-E Emulation 132 GEK-00029A