Grizzly G0555 Inventory

-14- model g0555/g0555p (mfg. Since 5/11)

Inventory

The following is a description of the main compo -

nents shipped with your machine. Lay the compo-

nents out to inventory them.

If any non-proprietary parts are missing (e.g. a

nut or a washer), we will gladly replace them; or

for the sake of expediency, replacements can be

obtained at your local hardware store.

NOTICE

If you cannot find an item on this list , care-

fully check the machine and the packaging

materials. Some of these items may be pre-

installed for shipping or become misplaced

during unpacking.

Shipping Inventory: (figures 4– 6) Qty

A. Bandsaw Assembly .....................................1

B. Upper Stand Braces ....................................2

c. Stand top ....................................................1

D. miter gauge Assembly ................................1

E. Stand Sides .................................................2

f. table w/insert & table pin ..........................1

G. table trunnion .............................................1

h. table lock Knobs 3⁄8"-16 .............................2

I. lower Stand Braces ....................................2

J. Front Fence rail ..........................................1

K. rear Fence rail ..........................................1

L. Fence Assembly ..........................................1

M. hardware (not Shown):

— hex Bolts m6-1 x 16 (Stand) ................. 16

— Flat Washers 6mm (Stand) ...................16

— Flange nuts m6-1 (Stand) ....................16

— Stand Feet 3⁄8"-16 x 2" (Stand) ................4

— hex nuts 3⁄8"-16 (Stand Feet) ..................8

— Flat Washers 3⁄8" (Stand Feet) ................8

— Carriage Bolts m8-1.25 x 16 (Stand) ......8

— Flange nuts m8-1.25 (Stand) ..................8

— hex Bolts m8-1.25 x 35 (Bandsaw) ........4

— Flat Washers 8mm (Bandsaw) ...............8

— lock Washers 8mm (Bandsaw) ..............4

— hex nuts m8-1.25 (Bandsaw) .................4

— hex Bolts m8-1.25 x 30 (trunnion) .........2

— lock Washers 8mm (trunnion) ...............2

— hex Bolt m8-1.25 x 80 (positive Stop) ....1

— hex nut m8-1.25 (positive Stop) .............1

— Fence Stand-off m6-1 x 20 (Fence) .......1

— lock handle m8-1.25 x 20 (Fence) .........1

—Cap Screws m6-1 x 16 Black (Fence) ....2

— hex Bolts m6-1 x 20 Black (Fence) ........2

— lock Washers 6mm Black (Fence) .........2

— Flat Washers 6mm Black (Fence) ..........2

—hex nut m8-1.25 Black (Fence) ..............1

— hex nut m6-1 Black (Fence)...................1

figure 4. Bandsaw assembly.

figure 5. other components.

figure 6. Fence components.