model g0555/g0555p (mfg. Since 5/11) -17-
Assembly
Some metal parts may have
sharp edges that can cause
minor injury. Please exam-
ine the edges of all metal
parts BEfORE handling
them and be careful WhILE
handling them.
To assemble the bandsaw:
1. lay one stand side flat on a protective sur-
face, then attach the upper and lower stand
braces, as shown in figure 8, with (8) m6-1
x 16 hex bolts, (8) 6mm flat washers, and (8)
m6-1 flange nuts.
Note: Only hand-tighten the stand fasteners
for now during these initial steps. Once the
stand is fully assembled you will be instructed
to fully tighten all fasteners.
figure 8. Upper and lower stand braces
attached to the stand side.
Upper
Stand Brace
Stand Side
lower
Stand Brace
x 8
2. Attach the remaining stand side to the assem-
bly, as shown in figure 9, with (8) m6-1 x 16
hex bolts, (8) 6mm flat washers, and (8) m6-1
flange nuts.
figure 9. Second stand side attached.
3. install the foot assemblies into the holes in
the bottom of the stand assembly, using (2)
3⁄8"-16 hex nuts and (2) 10mm flat washers,
as shown in figure 10.
Note: Adjust the feet so that they are approxi-
mately the same height—this will make level-
ing the stand easier in a later step.
figure 10. Stand foot installed (1 of 4).
x 4