Aligning Fence

To ensure accurate cutting when using the fence, the face of the fence must be parallel to the table miter slot and, thus, to the side of the blade.

Tools Needed

Qty

Hex Wrench 5mm.

..............................................1

To align the fence parallel with the miter slot:

1.Make sure the miter slot is parallel with the blade, as instructed in the previous Aligning Table procedure.

2.DISCONNECT BANDSAW FROM POWER!

3.Install the fence on the right side of the blade, even with the edge of the miter slot, then lock it in place.

—If the fence is parallel with the miter slot, no adjustment is necessary.

—If the fence is not parallel with the miter slot, proceed to Step 4.

-30-

4.Loosen the four fence adjustment cap screws shown in the figure below, adjust the fence parallel to the miter slot, then re-tighten the cap screws to secure the setting.

Cap Screws

Figure 41. Location of the fence adjustment cap

screws.

Model G0555/G0555P (Mfg. Since 5/11)

Page 32
Image 32
Grizzly G0555 owner manual Aligning Fence