-34- model g0555/g0555p (mfg. Since 5/11)
Blade Speed
the model g0555/g0555p offers blade speeds
of 1500 and 3200 Fpm. For general woodwork-
ing and most cutting operations, we recommend
using the 3200 Fpm speed. Keep in mind, the
results from different speeds are related to the
type of workpiece, the blade being used for the
operation, and the feed rate.
Use the chart below as a general guide to
blade speed:
Type of cutting Operation Blade Speed
(fPM)
most Species of Wood 3200
Super dense hardwood 1500
Fast/Average Feed rate 3200
requires Slow Feed rate 1500
rough edges Acceptable 3200
requires Smooth edges 1500
Quick, production Cuts 3200
detailed, intricate Cuts 1500
Speed changes are made by re-positioning the
ribbed v-belt on the pulleys.
Tools Needed Qty
hex Wrench 6mm ...............................................1
To change the blade speed:
1. diSConneCt BAndSAW From poWer!
2. open the lower wheel cover and loosen
the motor mount adjustment and hinge cap
screws shown in figure 44.
3. move the motor so that the adjustment cap
screw slides to the right of the slot. this will
release the tension on the ribbed v-belt.
4. position the v-belt belt on the pulleys as illus-
trated in figure 45 for the desired speed.
Note: Make sure the ribs of the V-belt are
well seated in the pulley grooves.
1500
FPM
Motor Pulley
Wheel Pulley
3200
FPM
figure 45. drive belt position for the different
speeds.
5. move the motor so that the adjustment cap
screw slides to the left of the slot.
6. Apply enough pressure on the motor so that
there is approximately 1⁄4" deflection of the
v-belt with moderate pressure from your fin-
ger between the pulleys, then re-tighten the
adjustment and hinge cap screws.
7. Close the lower wheel cover before re-con-
necting the bandsaw to power.
figure 44. locations of the motor adjustment
and hinge cap screws.
Adjustment
Cap Screw
hinge
Cap Screw