Power Connection

 

Test Run

 

 

 

 

 

 

After you have completed all previous setup instructions and circuit requirements, the machine is ready to be connected to the power supply.

To avoid unexpected startups or property dam- age, use the following steps whenever connecting or disconnecting the machine.

Connecting Power

1.Turn the machine power switch OFF.

2.Insert the power cord plug into a matching power supply receptacle. The machine is now connected to the power source.

Figure 25. Connecting power.

Disconnecting Power

1.Turn the machine power switch OFF.

2.Grasp the molded plug and pull it completely out of the receptacle. Do not pull by the cord as this may damage the wires inside.

Figure 26. Disconnecting power.

Model G0555/G0555P (Mfg. Since 5/11)

Once the assembly is complete, test run your machine to make sure it runs properly and is ready for regular operation.

The test run consists of verifying the following:

1)The motor powers up and runs correctly, and

2)the safety disabling mechanism on the switch works correctly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review Troubleshooting on Page 45.

If you still cannot remedy a problem, contact our Tech Support at (570) 546-9663 for assistance.

To test run the machine:

1.Make sure you have read the safety instruc- tions at the beginning of the manual and that the machine is set up properly.

2.Make sure all tools and objects used during setup are cleared away from the machine.

3.Verify that the machine is operating correctly by turning it ON.

—When operating correctly, the machine runs smoothly with little or no vibration or rubbing noises.

—Investigate and correct strange or unusual noises or vibrations before operating the machine further. Always disconnect the machine from power when investigating or correcting potential problems.

-23-

Page 25
Image 25
Grizzly G0555 owner manual Power Connection Test Run, Connecting Power, Disconnecting Power, To test run the machine