6.Unlock the blade tracking adjustment knob so the knob will rotate for adjustments in the next steps.
Note: The blade tracking adjustment knob controls the tilt of the upper wheel which, in turn, controls the center tracking of the blade.
7.Spin the upper wheel with one hand and use the blade tracking adjustment knob with the other hand to make the blade ride in the cen- ter of the bandsaw wheel tire.
8.After the blade consistently rides in the center of the wheel after several rotations, lock the blade tracking adjustment knob to secure the setting.
9.Close the upper wheel cover.
Note: For the best performance from your saw, regularly maintain the proper tracking of the blade.
Dust Collection
DO NOT operate this bandsaw without an ade- quate dust collection system. This bandsaw creates substantial amounts of wood dust while operating. Failure to use a dust collec- tion system can result in short and
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with the rating of the dust collector. To determine the CFM at the dust port, you must consider these variables: (1) CFM rating of the dust collector,
(2)hose type and length between the dust col- lector and the machine, (3) number of branches or wyes, and (4) amount of other open lines throughout the system. Explaining how to cal- culate these variables is beyond the scope of this manual. Consult an expert or purchase a good dust collection
To connect a dust collection hose:
1.Fit the dust hose over the dust port, as shown in the figure below, and secure in place with a hose clamp.
2.Tug the hose to make sure it does not come off.
Note: A tight fit is necessary for proper per- formance.
