4.Attach the cyclone funnel to the intake barrel with a barrel gasket between them, as shown in Figure 15, with (12)
(24)5⁄16" flat washers, and (12)
nuts.
Note: At the places where you see three holes close together as shown in Figure 16, only use the center hole for this step. The two outside holes will be used in the next step.
Barrel Gasket
Here
x 12
Figure 15. Cyclone funnel attached to intake
barrel.
5.Attach the collector mounting brackets to the intake assembly, as shown in Figure 16, using (8) 5⁄16"-18 x 1" hex bolts, (16) 5⁄16" flat washers, and (8) 5⁄16"-18 lock nuts.
x 8
Figure 16. Collector mounting brackets attached to intake assembly (collector shown upside down in this photo).
Model G0442/G0601 (Mfg Since 8/10)
6.Place a large piece of cardboard on the ground to prevent scraping the parts on the bare floor during the next steps.
7.With the help of another person, lay the stand assembly on its side on the cardboard and slide the collector assembly into the stand assembly, as shown in Figure 17.
x 8