19.Using the forklift, lift the entire assembly approximately 2" off the ground to gain clear- ance for filter installation.
20.Mount the two filters to the braces with brace gaskets between them, as shown in Figure 26, using (8)
x 8
Rubber 
Gaskets
Here
Figure 26. Canister filters mounted to the long
support braces.
21.Attach one roll of 3 x 15 x 700mm foam tape to both ends of each noise muffler, then connect them between the outlet ports and the canisters with the 8" flexible hoses and clamps, as shown in Figure 27.
Noise
Muffler
Figure 27. Noise mufflers connected between
the outlet ports and the canisters.
22.Using the forklift, raise the assembly up and attach the lower stand legs to the upper stand legs, as shown in Figure 28, using (24) 3⁄8"-16 x 3⁄4" hex bolts, (48) 3⁄8" flat washers, and (24) 3⁄8"-16 lock nuts.
x 24
Figure 28. Attaching lower legs to the initial
stand assembly.
23.Attach the casters to the bottom of the lower collection drum, as shown in Figure 29, using the (4) 3⁄8"-16 hex nuts, (8) 3⁄8" flat washers, and (4) 3⁄8" lock washers included in the box with the casters.
x 4
