shearing table alignment

Shearing Table

Alignment

The shearing table must be level along the entire length with the bottom flat stock shearing die for accurate cuts.

Tools Needed

Qty

Straightedge

1

Hex Wrench 8mm

1

Adjustable Wrench

1

To adjust the shearing table to the bottom flat stock shearing die:

1.DISCONNECT MACHINE FROM POWER!

2.Place a straightedge across the shearing table and the top of the bottom die in multiple locations (see Figure 64).

Figure 64. Straightedge on shearing table and

die.

G0646/G0647 50/65 Ton Ironworker

3.Loosen the shearing table mounting cap screws 1–2 turns.

4.Reach under the table and loosen the adjust- ment lock nuts (see Figure 65).

Adjustment

Hex Bolt

Lock

Nut

Figure 65. Shearing table adjustment lock nuts

and hex bolts.

5.Rotate the adjustment hex bolts to make the table level with the top of the bottom die along its entire length.

6.When you are satisfied with the adjustments, re-tighten the lock nuts and the table mount- ing cap screws.

-49-

Page 51
Image 51
Grizzly G0646, G0647 owner manual Shearing Table Alignment